DIY Easy Mold Removal Tips

Do-It-Yourself Mold Removal Made Easy

Everybody knows that mold, in all of its hindering glory, has not only been notorious for partaking in negative effects on your health, but it has also been known to blacken the grout lines in showers, cause discoloration in drywall, leave pronounced black spots on sidings, and is disreputable for rotting damp wood. That is why this DIY article might just help you in the long run to save your health and your home.

Surface Mold

When dealing with surface molds, you should first begin by ridding the surface of mold by soaking the bleach in the scrub brush and then cleaning the mildew from the walls. Once you have established this, then the next step in the cleaning process would be to clean the areas where surface molds are most prominent at least once a week as to prevent mildew from resurfacing. According to this Buffalo mold removal company however, if you notice significant mold in your property, you should call a professional company to come inspect it instead of trying to handle it yourself.

Material Mold

Going about this procedure is a bit tricky, especially when it involves molded material (such as cushions or insulation). It is best to begin by removing the material with a utility knife, once this is done it is important to then double wrap the material in plastic and tape it with duct tape before disposing of the damaged item.

Moldy Walls

You should begin this process by prying off the baseboard and trim. You can use a screwdriver to assist you in discovering the damages that have been caused by the mold spores. It is important that you open up the walls to get rid of the festering mold that has grown within them.

Once you have cleared out the damaged drywall, you should begin the cleaning process. Start with a standard wet/dry vacuum, and then begin scrubbing the tainted surface with your scrub brush and cleaning solution. After you have finished this, you should wipe the surface, but do NOT wash the treated surface. Once you have gone about all of this, you should wait three days before setting the area with a primer, as it is important that you ensure that the mold is completely gone before going about this process. Toxic Mold USA advise that when in doubt, you should usually just go ahead and call a pro anyway.

Precautionary Measures

First off, it is important that you use clothes that can be discarded after the cleanup, and to equip yourself with both gloves and a face mask that will prevent you from coming in contact with the chemicals from the cleaner and the untreated mildew. Also, make sure that you have equipped yourself with a cleaning solution such as bleach (1 to 8 bleach to water solution) and a scrub brush to wipe away the mold. Once you have acquired these instruments, then it is time to get down and dirty.

Leave a Reply

Your email address will not be published. Required fields are marked *